Dubaco DS-800 User Manual download pdf (Page 20)

This enables to set the scanning duration time for reading the same

barcode label, this function only available when the trigger mode is set in

“Continue” or “Momentary” or “Alternate” mode.(Note: when the

configuration is set as “0” or “00”, it means, no waiting time

needed. User can scan the same barcode label without any delay

time).

(1) Enter

(2) Good Read Time barcode

(3) Scan parameters from Hexadecimal /

Decimal table

(Range:0~250 = 0~25sec)

(4) OK

(5) End

This configuration enables to set the duration of scanner configuration

time. If user does not perform any actions after scanning the “Enter”

barcode (Configuration barcode) the setting mode will automatically exit.

(1) Enter

(3) Scan parameters from Hexadecimal /

Decimal table

(Range:0~255 = 0~4min15sec)

(2) Setup Timeout barcode

(4) OK

(5) End

Good Read Time

Setup Timeout

35 36

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

No comments

Dubaco DS-800 User Manual Page 20